emoate
-
Content count
2 -
Joined
-
Last visited
Never
Posts posted by emoate
-
-
Hi! I have a biostar n750a with a 955 be am3 running xp home
sp3 and the proper cpu driver installed per amd website.
Power now and smart fan turned on in bios but don't work!
It did work but I turned it off to do some benchmarking and
it has not worked sense any help would be good. I formated HD did clean install no help! I have vista 64 bit on another drive
with sp1. I did not see a 64 bit driver on amd web page for
vista I'm going to check cpuid for vista 64 cpuz. so I can see if it works on vista.
anyone know about over lcocking?
in Hardware
Posted
Over Clocking can be done safe. don't increase cpu volt causes
heat and not worth the risk. now you need to increase cpu buss
speed but watch your memory speed as you increase cpu buss so
will ram speed increase in mhz! now the better the MB the more
ajustments you will have! the best way to go is lower your ram
speed frist like 800 mhz down to 667 mhz now increase your cpu
buss from 200 to 233 mhz this is just me picking numbers to use
and a 33mhz jump may be to much but its a place to start again
alot of this needs a good MB because your pci,agp,pci-e need to
stay at 33 mhz,66 mhz,100 mhz so if your MB don't lock those your not go to OC very far. I have a e7200 45nm stock numbers
are 2.53Ghz 266 x 9.5 OC numbers (stock voltage) are 3.2Ghz 400
x 8 Intel cpu's let you go down on muti up to a point. hope this info helps you out. remember leave the volts alone for safe OC