Minisetup is not reading the INF file created with setupmgr.exe. I have a dir located at c:\sysprep and inside this dir is the sysprep.exe and the sysprep.inf. Any suggestions to why it is not reading the inf file?
Sysprep.inf shown below

;SetupMgrTag
[GuiUnattended]
AdminPassword=Not showing
EncryptedAdminPassword=Yes
OEMSkipRegional=1
OEMDuplicatorstring=WOODMERE_1.0
TimeZone=35

[UserData]
ProductID=XXXXX-XXXXX-XXXXX-XXXXX-XXXXX
FullName=""
OrgName="Lear Corporation"

[Display]
BitsPerPel=16
Xresolution=1024
YResolution=768

[TapiLocation]
CountryCode=1
Dialing=Tone
AreaCode=231
LongDistanceAccess="9"

[Identification]
JoinWorkgroup=WOODMERE

[Networking]
InstallDefaultComponents=Yes

[Unattended]
TargetPath=\WINDOWS

[Branding]
BrandIEUsingUnattended=Yes

[Proxy]
Proxy_Enable=0
Use_Same_Proxy=0

When you run sysprep, before you select reseal, make sure mini-setup is checked.

But shouldn't it look for the sysprep.inf if I select the mini setup or not? Or do I have to select miniseetup to use the sysprep.inf?