What's a good Dual P3/800 board

I am looking for a good dual P3/800 board I have not seen any reveiws on high end Dual P3 boards. Can someone help?

just have a look at the thread I started about dual PIII mobo.

Awx

I read your thread but you are looking for a dual 500. There are several on the market that run at 100mhz bus but only have 2X AGP and use only PC100 memory. I am looking for one with the 133mhz bus, 4X AGP and the new option to use the PC800 memory

Are you sure U wanna buy RDRAM ?
- $1000 for 128 MO :-(
- not so great, just read this article frim iXBT. (in this article RDRAM was 500$ but now it's $1000 for PC800 128Mo !!!!!)
- i820 is a sh@t (iXBT articles : i820 - the Story of One Failure and i820 test).

If you still wanna buy one of those i820 mobo :
ASUS
ASUS P3C-L.
Supermicro
no dual i820 card
Tyan
no i820 card
Epox
no i820 card
...

So be patient and save your money to buy RDRAM (and i820 support only 2 RDRAM).

And you can overclock your CPU to run at 133.

Awx

[This message has been edited by Awaxx (edited 08 February 2000).]

[This message has been edited by Awaxx (edited 08 February 2000).]

I just bought a Supermicro P6DBE at Fry's electronics. I had the new voltage regulators per Supermicro's web site. I had to boot the board up with a Celeron to flash it to get coppermine support, then I put in two PIII 650's. THe supermicro will only support 100mhz fsb coppermines. The multipliers go up to 8. The good thing about this board is that it is a BX chipset based board. I'm still not ready to use i820 or i840 yet.

Good Luck

Your lucky SlaveDog I want one but the one's found have the older voltage regulators Supermicro P6DBE what did it cost you ?.

So Kensan, you, sse, you'd rather buy a BX mobo. S I think the thread about dual Mobo is the one you should read.

Awx