Reset when browsing network drive

#1 BanditXL

newbie

Group: Members
Posts: 46
Joined: 25-March 01

Posted 20 February 2002 - 09:36 PM

I got this strange problem. Whenever I try to acces a network drive/share my computer spontainiasly(sp?) resets. I can't figure out what the problem is. I was wondering if anyone had the same problem and found a solution to it.

#2 OLEerror

enthusiast

Group: Members
Posts: 326
Joined: 29-September 00

Posted 21 February 2002 - 03:07 AM

Sounds like a conflict with the NIC. Try moving it to another PCI slot.

#3 BanditXL

newbie

Group: Members
Posts: 46
Joined: 25-March 01

Posted 21 February 2002 - 03:37 PM

Damn it didn't work

, but thanx for your reply. Maybe you have some other sugestions

#4 BanditXL

newbie

Group: Members
Posts: 46
Joined: 25-March 01

Posted 26 February 2002 - 04:32 PM

In some other thread I found out how to turn off the instant reset. I now get a Bluescreen with some information to work with (Never thought I would be happy to see a bluescreen, after this I hope to never see one again).

This is what I get:

DRIVER_IRQL_NOT_LESS_OR_EQUAL

[then some useless info from MS]

Tech info:
stop 0x000000D1 (0x0200000C, 0x00000002,0x00000000, 0xF2EF237C)

tcpip.sys adress F2EF237C base at F2EF0000 Datestamp 3b7dc580

I already tried to replace the tcpip.sys with a new one from the CD, unfortunally it didn't help. So I thought I'd post this info here, hoping you guys could give a tip on what to do.

#5 ViperZ2000

journeyman

Group: Members
Posts: 60
Joined: 26-February 02

Posted 26 February 2002 - 10:07 PM

Sounds like you may want to remove TCP/IP and re-add it. It's very unusual that the stack gets corrupt but it is worth a try and 10 minutes of your time. Hope this helps....

#6 ViperZ2000

journeyman

Group: Members
Posts: 60
Joined: 26-February 02

Posted 26 February 2002 - 10:12 PM

I also had a similar issue with XP on a fresh load last week where the nic.sys (actually a 3c???.sys) gave me a blue screen and rebooted.

I fixed this by running Norton System Works (run and repair) directly from the CD. This fixed whatever the error was.

I had almost 85 problems with shortcuts and registry entrys on a fresh XP load...no other software but the OS!!!

Good luck!

#7 mike3169

newbie

Group: Members
Posts: 47
Joined: 27-December 01

Posted 09 March 2002 - 06:15 PM

0x000000D1...What it means?

This may just make it worse, but this is what your error code means according to MSDN.

Mike

#8 BanditXL

newbie

Group: Members
Posts: 46
Joined: 25-March 01

Posted 10 March 2002 - 05:27 PM

Well, I tryed every thing and eventually just formated the drive and installed XP once again. Everything seems to be running fine now (except I can't get nero to install).

Thanx for the help